User Tools
novo_motion_interface_control
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
novo_motion_interface_control [2021/02/04 20:05] dlm [Edit Settings] |
novo_motion_interface_control [2021/02/05 21:19] (current) dlm |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | [[main_page|NovoMotion Outbound | ||
| ====== NovoMotion Interface Control ====== | ====== NovoMotion Interface Control ====== | ||
| Line 12: | Line 12: | ||
| + | \\ | ||
| ====Start Phantom/ | ====Start Phantom/ | ||
| Line 22: | Line 22: | ||
| **NOTE:** If the interface phantom is stopped, the service phantoms will continue on to completion of their current task. If an administrator does not want to wait for the service phantom to compete, they would use normal U2 logoff functionality to stop the process. This would most often occur if a batch load of data was occurring and a system reboot was deemed necessary. | **NOTE:** If the interface phantom is stopped, the service phantoms will continue on to completion of their current task. If an administrator does not want to wait for the service phantom to compete, they would use normal U2 logoff functionality to stop the process. This would most often occur if a batch load of data was occurring and a system reboot was deemed necessary. | ||
| + | \\ | ||
| ====Edit Settings==== | ====Edit Settings==== | ||
| The Edit Settings button can be used to set up information about how the user wants the phantom to run. | The Edit Settings button can be used to set up information about how the user wants the phantom to run. | ||
| Line 53: | Line 53: | ||
| + | \\ | ||
| Line 74: | Line 74: | ||
| + | \\ | ||
| Line 90: | Line 90: | ||
| + | \\ | ||
| === The Client Application Tab === | === The Client Application Tab === | ||
| Line 103: | Line 103: | ||
| | Refresh/ | | Refresh/ | ||
| - | + | \\ | |
| - | + | ||
| - | + | ||
| Line 128: | Line 125: | ||
| * **NoDecInOrd** removes decimal places after ordinal evaluation and prior to sending to SQL | * **NoDecInOrd** removes decimal places after ordinal evaluation and prior to sending to SQL | ||
| + | \\ | ||
| + | === The OS Boot Commands Tab === | ||
| - | ==== The OS Boot Tab ==== | ||
| - | |||
| - | |||
| - | |||
| - | {{: | ||
| + | This is used for specialized operating system commands. Please contact NovoRoi Systems for further information. | ||
| - | * This is used to specify | + | \\ |
| + | [[main_page|NovoMotion Outbound | ||
novo_motion_interface_control.1612469115.txt.gz · Last modified: 2021/02/04 20:05 by dlm
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
